(Probably not, but this was easier than figuring out how to do it properly): If you try to attach a smooth surface to a smooth surface, you're gonna have a bad time (I had to re-do 3 of my standoffs).ĭe-guts-ing my other PSU required cutting a notch out of it. IMPORTANT: Be sure to score (scratch-up / groove) the standoffs and the case before you attempt this. I used JB Weld to attach the standoffs back to the case. After I made sure the measurements were correct, I made a cardboard version to hold the standoffs in place as they dried. I based my final placement on lining up with the PCI slots and I/O panel. I punched the standoffs (re-used after I popped them off) through the paper and screwed them in to makes sure the spacing was correct. Next, I measured the spacing I would need for the standoffs by tracing the motherboard on a piece of paper and marking the holes. I only removed as much material as I had to while trying to keep a clean look. In order to have this be usable I of course had to cut out the I/O panel. Power for the graphics card would have to be routed or cut of course. As you can see It barely fits in under the acrylic panel. The first thing I did want to do was get a test fit and see how I could squeeze it all in. This has been documented before and I didn't really feel the need to. ![]() The tear down process is pretty straightforward: just unscrew everything you can and pull it out. This is still a slowly on-going project with a few nit picks that I need to take care of but I suppose my perpetual postponing of these final touches is in the spirit of the build after all. I also wanted to maintain a pretty much stock look. Because of this, I wanted to figure out the absolute LEAST amount of work I could do and still end up with what I wanted: taking my rig and effectively just copy/pasting it into a G5. As an engineering student, I am very focused on problem solving and "efficiency" (which usually means LAZINESS). Several people on here have done some very nice mods and ended up with beautiful results. ![]() There's no denying that the G5 is sexy case. ![]() If you're looking for mind-blowing innovation, you might want to just stop reading right now. I know that G5 case mods aren't exactly a "new" concept.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |